47
Setup for MULTI DISPLAY
Item Details
Video Wall Uniformity
Reduces the peak of brightness for each display to enable as uniform display as possible.
Select “Off” or “On”.
The brightness depends on each
display’s setting.
The brightness difference is
minimized.
Off On
Note:
If you set Video Wall Uniformity to On, the following menus will be unavailable and these
settings will be xed to the initial values.
Picture menu: Colour, Hue, Input level (Advanced settings)
You can set the remote control ID when you want to use this remote control on one of several different displays.
Note:
To operate this function, please purchase ID remote controller sold separately.
Object model : EUR7636090R
1
2
3
Switch to on the right side.
Press the
button on the remote control.
Press one of
- , for the tens digit setting.
Press one of
- , for the units digit setting.
4
Notes:
• The numbers in 2, 3 and 4 should be set up quickly.
• Adjustable ID number range is 0 - 99.
• If a number button is pressed more than two times, the rst two numbers become the ID number for the remote
control.
ID Cancellation
Press button on remote control. (This has the same effect as pressing the , , buttons at the same time.)
Notes:
• Set the Remote ID “On” to operate the ID remote control.
If Remote ID is set to “On”, you can use the remote control without identical ID number during option menu display.
(see page 55)
• The ID remote control cannot be used when ID select is set to anything other than 0, and the remote control ID is
not the same as the ID select number (see page 55).
ID remote control button operation
The operation is the same as normal remote control except for the button.
ID Remote Control Function
To Next Page
Loading...
