Panasonic TH-42PF50E

50
Setup for Input Signals
Component / RGB-in select
Component RGB
Select to match the signals from the source connected to the Component / RGB or PC input terminals.
Y, P
B
, P
R
signals
“Component”
RGB signals
“RGB”
Note:
Make setting of the selected input terminal (COMPONENT/RGB IN or PC IN).
YUV / RGB-in select
YUV RGB
Select to match the signals from the source connected to the DVI input terminals.
YUV signals
“YUV”
RGB signals
“RGB”
Notes:
• Selection may not be possible, depending on which optional board is installed.
• Make setting of the selected input terminal (SLOT or DVI-D IN).