24
123
456
789
0
SD REC
EXIT
Start recording?
Not enough memory
Current setting
Rec time 180min
Rec mode Economy
Recordable at 15min
SD REC
SD REC
Note
•
You cannot record the copy protected signals.
•
If the Off timer function is activated or press the Standby On / Off button on the
remote control during recording, the recording will not stop.
•
Do not press the On / Off switch on the TV during recording. Otherwise the fi le
will be broken.
•
Do not remove the SD card while recording. The data being recorded and
other data stored on the SD card may become unreadable.
•
SD recording may not be fully compatible or playable in some PC software or
PDA devices.
•
When two pictures are shown on the same screen as Multi window functions,
the main window is the one that is recorded. (p. 10)
•
If the signal system is changed during recording, it cannot be recorded
completely.
•
The signals without video (only audio) cannot be recorded completely.
Recording a Programme on SD Card
While watching a programme
2
To stop
3
The TV channels can be recorded on the SD card. The recording is not available for AV input signal.
During recording, it is possible to watch other terminals input signal.
•
Start recording
•
Cancel
EXIT
■
Should such a message appear
Insert the SD Card (p. 23)
1
This product is licensed under the MPEG-4 patent portfolio license for the personal and non-commercial
use of a consumer to (i) encode video in compliance with the MPEG-4 Video Standard (“MPEG-4 Video”)
and/or (ii) decode MPEG-4 Video that was encoded by a consumer engaged in a personal and non-
commercial activity and/or was obtained from a licensed video provider. No license is granted or implied
for any other use. Additional information may be obtained from MPEG LA. See http://www.mpegla.com.
Card capacity is not enough.
•
Continue
(Recording is stopped when
the card capacity is full.)
•
Cancel
EXIT
•
Recordable time is displayed
if the recording time is not set (p. 25).
(During the confi rmation message appears)
To Next Page
Loading...
