Panasonic TH-42PW3 - SYNC; Pull-in Range; Clamp Position; H-Freq. (kHz);V-Freq. (Hz)

SCHEMA*99
11.1.1 Display Indication
TOP PREVIOUS NEXT
1.Self-check is used to automatically check the bus line controlled circuit of the Plasma display.
2.To get into the Self-check mode, press the volume down
button on the customer controls at the
front of the set, at the same time pressing the OFF-TIMER button on the remote control, and
the screen will show :-
If the CCU ports have been checked and found to be incorrect
Or not located then " - - " will appear in place of " OK "
TOP PREVIOUS NEXT