Panasonic TH-42PW5

32
Setup for Input Signals
Component/RGB-in Select
Select the input signals to be connected by installing the Optional Terminal Board.
(Refer to the service manual for the optional Terminal Board.)
Select to match the signals from the source connected to the Component/RGB input terminals.
Y, PB, PR signals “Component”
R, G, B, HD, VD signals “RGB”
INPUT
SURROUND
VOL
NR
PICTURE
SOUND
SET UP
ASPECT
PICTURE
POS. /SIZE
SET UP
1
2
Press to display the Setup menu screen.
Press to select the “Component/RGB-in
Select”.
Press to select the desired mode.
Press to exit from adjust mode.
3D Y/C Filter – For NTSC AV images
Select “Signal” from the “Setup” menu during AV(S Video) input signal
mode. (“Signal [AV]” menu is displayed.)
3D Y/C Filter
(
NTSC
)
Colour system
3:2 Pulldown
On
Auto
Off
Panasonic Auto
(
4:3
)
4 : 3
Signal
[
AV
]
Press to select the “3D Y/C Filter (NTSC)”
Press to set On/Off.
R
Press to exit from adjust mode.
Press (ACTION) button
MULTI DISPLAY Setup
Set up TIMER
Setup
Signal
Screensaver
Component/RGB-in select
RGB
OSD Language
English
(
UK
)
MULTI DISPLAY Setup
Set up TIMER
Setup
Signal
Screensaver
Component/RGB-in select
RGB
OSD Language
English
(
UK
)
Component RGB
R
Notes:
(1) When On, this setting only affects NTSC input signals.
(2) 3D Y/C Filter does not operate by input signal from Scart Terminal.
With the optional Scart/Component Terminal Board installed, 3D Y/C Filter does not operate by input signal from
Scart Terminal of the board.