TH-50PF30U
4. Disconnect the connectors (HX1, HX2).
5. Remove 2 Hexagonal-Head screws and 1 screw of HX-
Board and then remove HX-Board.
2. Remove 2 screws and then remove the Fan Block (A)
and the Fan-Duct Barrier (A).
8.6. Removal of A-Board
1. Remove the HX-Board Block.
(Refer to Removal of HX-Board)
2. Disconnect the connectors (A5, A11, A13, A16, A22,
A37).
3. Remove the flexible cables from the connectors (A1,
A15).
4. Remove 4 screws and then remove A-Board.
Note: when fixing A-Board
• Put the flexible Cable between the Fixed Metal and A
Board when Connect the flexible Cable to the connector
(A1).
8.7. Removal of Fan
1. Disconnect the Fan Relay Connectors.
3. Remove each 1 screw (♦ ) and then remove the Fan from
the Fan Fixed Metal.
4. Remove each 4 Fan Corner Sponges from the Fan.
4
# 4
т ы
ИЗЯ!У-
ban Corner Rubber Cushion Щ
5. Reassemble the Fans in reverse order.
6. Remove the Sheet.
23
To Next Page
Loading...
