Panasonic TH-50PH30E - Removal of Fan; Removal of P-Board; Removal of AC Inlet Assy; Removal of Speaker Terminal Block

22
TH-50PH30E / TH-50PH30ER
Note: when fixing A-Board
• Put the flexible Cable between the Fixed Metal and A-
Board when Connect the flexible Cable to the connector
(A5).
8.5. Removal of Fan
1. Disconnect the Fan Relay Connector.
2. Remove 2 screws and then remove the Fan Block.
3. Remove 1 screw and then remove the Fan from the Fan
Fixed Metal.
4. Remove each 4 Fan Corner Sponge from the Fan.
5. Reassemble the Fan in reverse order.
6. Stick the Fan Sponge around the Fan.
Note:
The Fan Sponge is not re-usable.
Please use a new one when Fan exchange.
8.6. Removal of P-Board
1. Disconnect the connectors (P2, P9, P11, P16, P25, P34,
P35).
2. Remove 9 screws and then remove P-Board.
8.7. Removal of AC Inlet Assy
1. Disconnect the connector (P9).
2. Remove 2 screws ( ) and then remove the AC Cord
Clamper A.
3. Remove 1 screw ( ) and then remove the AC Inlet Assy.
8.8. Removal of Speaker Terminal
Block
1. Disconnect the connector (H37).
2. Remove 1 screw and then remove the Speaker Terminal
Block (H3-Board).
8.9. Removal of SN-Board
1. Disconnect the connectors (SN2, SN3).
2. Remove the flexible cable from the connectors (SN20,
SN21, SN22, SN23, SN24, SN25, SN26).