27
TH-50PH30E / TH-50PH30ER
12. Remove the flexible cables from the connectors (SN21,
SN22, SN23, SN24, SN25, SN26).
13. Disconnect the connectors (SN2, SN3).
14. Remove the flexible cables from the connector (SN20).
15. Remove 6 screws and then remove SN-Board.
16. Disconnect the connector (SS11).
17. Remove the flexible cables from the connectors (C23,
SS52, SS55).
18. Remove 3 screws and then remove SS-Board.
19. Disconnect the connectors (C25, D25).
20. Remove the flexible cables from the connectors (C11,
C21).
21. Remove 4 screws and then remove D-Board.
22. Remove 5 screws and then remove P-Board.
23. Remove the flexible cable from the connectors (C10,
C20).
24. Remove 7 screws ( ).
Note: when fixing Handle Fixing Metal (L, R)
• Screw on 2 screws (1) firstly.
25. Pull the bottom of the Plasma Display Panel forward
(arrow1).
To Next Page
Loading...
