Panasonic TH-50PV500A - Remove the S-Board; Remove the Plasma Panel Section from the Front Frame (Glass); Replace the Plasma Panel (Finished)

6.32. Remove the S-Board
1. Remove the screw (×2 ).
2. Disconnect the couplers (S1).
3. Remove the screws (×2
) and remove the S-Board.
6.33. Remove the Plasma panel
section from the Front frame
(glass)
1. Remove the front frame and the plasma panel fastening
screw (×8
).
2. Remove the front frame and the stand brackets fastening
screw (×6
).
3. For leaving the plasma panel from the front frame, pull the
bottom of the front frame forward, lift, and remove.
6.34. Replace the plasma panel
(finished).
1. Place the new plasma panel (finished) on the flat surface of
the table (covered by a soft cloth), with the plasma panel
surface facing downward.
2. Attach the C1, C2, C3, C4, C5-Board and the C6-Board,
connect the flexible cables (×7) from the Plasma panel to
the C1, C2, C3, C4, C5-Board and C6-Board, and fix the
flexible cable holders.
3. Attach the Hooks (left, right) and fit the stand brackets (left,
right) to the new plasma panel.
4. Place the plasma panel section on the servicing stand.
5. Attach the front frame and the each P.C.Board and so on,
to the new plasma panel.
* When fitting the front frame, be careful not to allow
any debris, dust or handling residues to remain
between the front glass and plasma panel.
19
TH-50PV500A / TH-50PV500H / TH-50PV500M