53
English
●
This menu will be greyed out and cannot be set under
the following conditions.
•
[Failover/Failback] is set to the item other than
[Off]. (see page 53)
•
[Power management mode] is set to [Input
detection]. (see page 57)
•
[Input lock] is not set to [Off]. (see page 61)
•
When [Setup] - [Image settings] - [No signal image
settings] - [Display setting] is set to [On]. (see page
61)
●
If the input is changed by this function, the last input
is selected when the power is turned on next time.
If you wish to retain the original input when the power
is turned on, set [Initial input] to the original input.
(see page 51)
Failover/Failback
Automatically switches to the backup input if an
interruption of video occurs.
Note
●
When [PC] is selected for [Primary backup input] or
[Secondary backup input], this operates only when
[PC input mode] is set to [PC]. (see page 75)
●
MEMORY VIEWER input is excluded from this
function.
[Input change mode]
[Off]:
Disables the Backup Input function.
Failover/Failback
Input change mode Off
[Quick]:
Promptly switches to the backup input if an
interruption of video occurs.
The backup video signal needs to be in the same
format as the (main) input in use for viewing.
Upon switching to the backup input, the video and
audio adjustment values for the (main) input used
for viewing will be inherited.
Failover/Failback
Input change mode
Primary backup input
Auto switch back mode
Backup input change
Secondary backup input
Main input
Current input
Quick
HDMI1
HDMI2
Disable
Active
HDMI2
Main input
Changing mode High speed
[Normal]:
Switches to the backup input if an interruption of
video occurs.
The backup video signal does not need to be in the
same format as the (main) input in use for viewing.
Upon switching to the backup input, the video and
audio adjustment values for the backup input will
be used.
To Next Page
Loading...
