Panasonic TH-55EQ1U - Page 67

67
English
Note
●
To use a DHCP server, make sure the DHCP
server is started.
●
Contact your network administrator for details on
[IP address], [Subnet mask] and [Gateway].
●
Shipping condition
[DHCP]: Off
[IP address]: 192.168.0.8
[Subnet mask]: 255.255.255.0
[Gateway]: 192.168.0.1
[Command port]
Set the port number used for command control.
Select [Command port] and press <ENTER> to set
the number.
●
Theavailablesettingrangeis1024‒65535.
●
Entering numbers (see page 66)
Note
●
When the PJLink protocol is used, the port setting is
not necessary.
[MAC address]
Displays the MAC address of this unit.
■ [Network status]
Checks the current Network settings status.
192. 168. 0. 1
255. 255. 255. 0
192. 168. 0. 8
12:34:56:78:9A:BC
Network status
DHCP
IP address
Subnet mask
Gateway
MAC address
Off
■ [AMX D. D.]
Set whether to allow the Display to be detected by AMX
Device Discovery.
[On]:
Enables detection by AMX Device Discovery.
[Off]:
Disables detection by AMX Device Discovery.
●
For more details, visit the following web site.
http://www.amx.com/
■ [Crestron Connected]
When this function is set to [On], the Display can be
monitored or controlled via the network using equipment
and application software of Crestron Electronics, Inc.
This Display supports the following application software
from Crestron Electronics, Inc.
•
RoomView Express
•
Crestron Fusion
Crestron Connected is a function to connect to a system
developed by Crestron Electronics, Inc. which manages
and controls multiple system devices connected to the
network.
●
For details of Crestron Connected, refer to the
Crestron Electronics, Inc. web site (Provided only in
English).
http://www.crestron.com/
For the download of “RoomView Express”, refer to
the Crestron Electronics, Inc. web site (Provided only
in English).
(https://www.crestron.com/en-US/resources/get-
roomview)
■ [USB memory network settings]
Sets whether to permit the network setting using the
USB memory device. (see page 115)
[Permit]:
Permits USB memory network settings.
[Prohibit]:
Prohibits USB memory network settings.
Note
●
This function is set to [Permit] as factory default.
●
Once the network setting is done with USB memory
device, this function is set to [Prohibit].
■ [LAN control protocol]
Select the LAN control protocol.
[Protocol 1]:
Control with the Panasonic Display sequence.
[Protocol 2]:
Control with the sequence that is compatible with
Panasonic Projector.
Note
●
For PJLink and WEB browser control, the operation is
possible regardless of the setting.
●
When operating the “Multi Monitoring & Control
Software”, select [Protocol 2].
■ [Reset]
You can reset the network setting to the factory default
of the Display.
Select [Yes] with
and press <ENTER>.
Network settings
Reset
Yes No
Note
●
The settings for [NTP synchronization], NTP server
and [Time zone] will be reset to the factory default.