86
English
■ Detail control page
The detailed functions of the unit can be performed.
Click [Display control]→[Advanced control].
Enter a command. Use the same command used for
the serial control.
Response from the unit is displayed.
Command is sent and run.
Note
●
After the settings are changed, it may take a while till
the display status is displayed.
■ Network config page
When connecting by logging in with administer
privileges, you can make detailed settings for network
related to display.
LAN settings
1
Click [Detailed set up] in the menu.
2
Click [Next].
The settings window appears, showing the current
settings.
•
To change the LAN settings, click [Change].
•
To return to the previous window, click [Back].
3
Complete the detailed settings and
click [Next].
In this window, DNS server settings can be made as
well as address information set on the [LAN setup]
menu of the display.
After all required items have been entered, click
[Next]. Then, a confirmation window appears.
Note
●
When [DHCP ON] is set, if the DNS server
address is acquired from the DHCP server, the
acquired address is valid.
4
Click [Submit].
The settings will be registered.
Note
●
Changing the setting of LAN while connected with
LAN might disconnect the connection.
To Next Page
Loading...
