SECTION 2 DISASSEMBLY PROCEDURES
<65BFE1W>
2.1. Precautions
* Before Disassembling, turn the display off and disconnect the power plug from the wall outlet.
* When tore off sticky tapes, please use a new thing without reusing it on the occasion of assembling.
TH-50LFB70U/TH-50LFB70W
7.2. Preparations
• When you exchange modules or board, in order to make it
discharge from an electrolytic condenser, please wait for 1
• To avoid damaging the LCD panel, lay out a soft cloth or
towel and lay down the unit so the front side is facing down.
Precautions when replacing each component
• When you replace each component, please be sure to carry
out following procedure as below.
• Be careful not to overtighten the screws when replacing
each module.
• Please remove a clamper and a wire processing tape if
needed in the repaire.
• In carrying out Section 7.7. or later, please execute the
Chapter 7.6. and 7.5. in advance.
1. Remove the screw and then remove the WI-FI Module
(Dongle).
• When you exchange modules or board, in order to make it discharge from an electrolytic condenser, please wait for 1 minute
after the power supply end.
• To avoid damaging the LCD Panel, lay out a soft cloth or towel, and turn the front of the unit down, and lay down so that the
Precautions when replacing each component
• When you replace each component, please be sure to carry out following procedure as below.
• Be careful not to overtighten the screws when replacing each module.
• Please remove a clamper and a wire processing tape if needed in the repair.
• Please remove a clamper and a wire processing tape if needed in the repair.
TH-65LFB70U/TH-65LFB70W
• When you exchange modules or board, in order to make it
minute after the power supply end.
• When you replace each component, please be sure to carry
• Please remove a clamper and a wire processing tape if
needed in the repaire.
• In carrying out Section 7.7. or later, please execute the
Chapter 7.6. and 7.5. in advance.
7.3. Replacement of WI-FI Module
(Dongle)
1. Remove the screw and then remove the WI-FI Module
(Dongle).
Soft cloth and Towel