Notes on Usin
Wireless Connection
Wired LAN
se stra
t or crossover
ca
e t
at
s compat
e w
t
cate
or
5 or a
ove
Whether strai
ht cable, crossover cable or both can be used varies dependin
on the s
stem con
i
uration. For details,
onsult
our s
stem administrator.
When settin
up the Displa
at a place, where electric statistic occurs often, take a sufficient anti-static measure before
tart us
n
When the Displa
is used at a location, where static electricit
occurs o
ten, such as on a carpet, communications o
the DI
ITAL LINK and the wired LAN are disconnected more o
ten. In that case, remove static electricit
and the noise
ource that ma
cause problems with an antistatic mat, and re-connect the DIGITAL LINK and the wired LAN.
In rare cases, the LAN connection is disabled due to static electricit
or noise. In that case, turn off the power of the
Displa
and the connected devices once and then re-turn on the power.
onnect the DI
ITAL LINK and the LAN.
The Displa
ma
not work properl
due to stron
radiowave
rom the broadcast station or the radio.
I
there is an
acilit
or equipment, which outputs stron
radiowave, near the installation location, set up the Displa
at a location sufficientl
far from the source of the radiowave.
r, wrap the LAN cable connected to the DIGITAL LINK
terminal b
usin
a piece of metal foil or a metal pipe, of which is
rounded at both ends
va
a
e w
re
ess L
c
anne
The channels
requenc
ran
e
that can be used di
er accordin
to the countr
or re
ion. Re
er to the table below
Countr
or re
ion
tandard Channels used Frequenc
band
Center frequenc
l
l
EEE
2.11
Passive scannin
.1
Hz -
.
2
Hz
IEEE802.11b/
/
Passive scannin
2.412
Hz - 2.472
H
The frequenc
and channel differ dependin
on the countr
The passive scannin
is performed b
chan
in
radio to the channel bein
scanned in each countr
Please use the wireless LAN
eature in compliance with the laws o
each countr
¼
For Mexico
peration of this equipment is sub
ect to the followin
two conditions
1
this equipment mi
ht not have a harm
ul inter
erence an
2
this equipment must accept an
interference, includin
one that mi
ht cause it to malfunction
or
ama
ca
This product contains T
pe Approved Modules b
Jamaica.•