124
Troubleshooting (Advanced)
Can not record with microphone z Use a condenser microphone.
z Some settings may have to be made depending on the microphone.
When using a monaural microphone with a 2-terminal plug:
A Click (Start) - [Control Panel] - [Hardware and Sound] - [Sound] -
[Recording] - [Microphone] - [Properties], and then add a check
mark for [Mono Microphone].
A Click [start] - [Control Panel] - [Sound, Speech, and Audio Device] -
[Sounds and Audio Devices] - [Audio], and click [Volume] in “Sound
recording”.
B Click [Options] and add a check mark for [Advanced Control].
C Click [Advanced] in “Mic Volume” and add a check mark for [2 Mono
Mic], then click [Close].
When recording in stereo using a stereo microphone:
A Click (Start) - [Control Panel] - [Hardware and Sound] - [Sound] -
[Recording] - [Microphone] - [Properties], and then remove a check
mark for [Mono Microphone].
A Click [start] - [Control Panel] - [Sound, Speech, and Audio Device] -
[Sounds and Audio Devices] - [Audio], and click [Volume] in “Sound
recording”.
B Click [Options] and add a check mark for [Advanced Control].
C Click [Advanced] in “Mic Volume” and remove a check mark for [2
Mono Mic], then click [Close].
When logging on (e.g., resuming the
computer), audio is distorted.
z Perform
the following steps to change the audio settings to prevent audio output.
A Right-click the desktop and click [Personalize] - [Sounds].
B Remove the check mark from [Play Windows Startup sound].
“There was an error updating the reg-
istry” appears when Sound Recorder
is started.
z Sound Recorder is started by a limited account user whose language setting is
not the same as the administrator user who last started Sound Recorder. This
does not affect the operation.
Sound
To Next Page
Loading...
