18
Sleep or Hibernation Functions
To enter standby, click [start] - [Turn Off Computer] - [Stand By].
To enter hibernation, click [start] - [Turn Off Computer], then press and hold
Shift
and click [Hibernate].
CAUTION
While the computer is entering sleep
*3
or hibernation
z Do not:
• Touch the keyboard, touch pad, touchscreen (only for model with touchscreen), or power switch.
• Use an external mouse or other peripheral devices.
• Connect or disconnect the AC adaptor.
• Operate the wireless switch.
• Close or open the display.
• Insert and remove the SD Memory Card.
Wait until the power indicator blinks green (sleep
*3
) or goes off (hibernation).
z It may take 1 or 2 minutes to enter sleep
*3
or hibernation.
z Immediately release the power switch. After releasing the switch, do not operate it until the power indicator blinks or
goes off.
If you slide and hold the power switch for longer than 4 seconds, the computer will forcibly shut down and unsaved data
will be lost even if you have set [When I press the power button] to any item in [Choose what the power button does] of
[Power Options] in [Control Panel].
If you slide and hold the power switch for longer than 4 seconds, the computer will forcibly shut down and unsaved data
will be lost even if you have set [Shut down] in [When I press the power button on my computer] (Î page 15 “Setting
Sleep or Hibernation”).
In sleep
*3
or hibernation
z Do not attach or remove a multimedia pocket device (excluding a second battery pack)
*5
and peripheral devices.
Doing so may cause malfunction.
z Power is consumed in sleep
*3
. Power consumption may increase when a PC Card is inserted. When power is
exhausted, the data retained in memory will be lost. Connect the AC adaptor when using the sleep
*3
function.
z Do not turn on/off the wireless switch.
To Next Page
Loading...
