36
Multimedia Pocket
2 Slide the latch (A) and open the cover.
3 Press the release handle (B).
The release handle pops out.
4 Pull the release handle (B) to draw out the device partway, and hold
the device on its both sides to remove.
5 Carefully insert the device into the multimedia pocket by pushing
both corners until it surely fits in the slot.
z Press the release handle (C) to set in.
z Insert the device with the label side up.
6 Close the cover until it clicks.
CAUTION
z Hold the device by both sides. Otherwise the device may be damaged.
z When raising the slot side upward and inserting the device, be careful not to apply any impact to the device.
To Next Page
Loading...
