6
Standby/Hibernation Functions
• When any of the multimedia pocket device indicator
*1
, the hard disk drive indicator and the SD Memory Card indi-
cator is on.
• When playing/recording audio files or displaying motion video such as MPEG files.
• When playing a DVD-Video.
• When writing to a disk.
• When using communication software or network function.
• When using a PC Card.
(If the card fails to work normally, restart the computer.)
z If a disc formatted with B’s CLiP is inserted into the CD/DVD drive (while is displayed on the notification area), the com-
puter cannot enter standby or hibernation mode. Eject the disc beforehand.
z The computer does not enter standby/hibernation immediately after resuming. Wait approximately one minute.
*1
Except when using a second battery pack
To enter standby/hibernation
1 Close the display, or press and hold the power button (A) until a
beep
*2
sounds.
Standby: The power indicator (B) blinks green.
Hibernation: The power indicator (B) goes off.
z You can alternatively use the Windows menu to enter standby/hibernation. To
enter standby, click [start] - [Turn Off Computer] - [Stand By]. To enter hiberna-
tion, click [start] - [Turn Off Computer], then press and hold
Shift
and click
[Hibernate].
CAUTION
While the computer is entering standby/hibernation
z Do not:
• Touch the keyboard, touch pad, or power button.
• Use an external mouse or other peripheral device.
• Connect or disconnect the AC adaptor.
• Close or open the display.
Wait until the power indicator blinks green (standby) or goes off (hibernation).
z It may take one or two minutes to enter standby or hibernation.
Entering/Resuming from Standby or Hibernation
To Next Page
Loading...
