20
1 Power off your computer ( "Starting Up/Shutting Down")
Do not shut down using the suspend* or hibernation mode.
* With Windows 98, the "Suspend" is called "Standby".
2 Removing the device
Press the MP release button firmly. The device will eject slightly.
2
Remove the device by holding both sides of the device.
Installing the device
Gently insert the device into the multimedia pocket by pushing on
both corners until it clicks into place.
3 Turn your computer on
CAUTION
Using a Multimedia Pocket Device
You may use an included CD-ROM pack (CF-VCD711), an optional DVD-ROM drive
pack (CF-VDD711/CF-VDD712) or an optional SuperDisk drive pack (CF-VFS711) by
removing your floppy disk drive from the multimedia pocket.
Installing/Removing a Multimedia Pocket Device
MP Release Button
Please handle the device as shown
(holding both sides). Otherwise, the de-
vice may be damaged. Also, do not ap-
ply excessive downward force on the
device. The projections at the bottom
of a device become deformed.
Be sure the shape of the lock at the
bottom of a device does not become
deformed. Do not insert a device that
has become deformed into the multi-
media pocket. The device may become
impossible to remove later.
2
Lock
Projections
Insert the device with the
label side facing up.
CAUTION
Do not install the device upside-down.
The bottom of the drive may become disfigured.
NOTE
Whether the device is properly recognized or not can be confirmed
in [Main] of the Setup Utility. If the device is not recognized, power
OFF the computer and reinstall the device.
To Next Page
Loading...
