6
Function
Suspend function Hibernation function
Where data is saved to
Memory Hard disk
Speed
Fast Somewhat slow
Requires power supply
Yes (if power is cut, all data is lost) Power is not required to maintain data
Suspend Mode
or
Hibernation Mode
Setting the Suspend or Hibernation Function
If you want to immediately start up and continue an application after shutting down your
computer, you can do so by using the suspend or hibernation function.
Starting Up Your Computer Quickly
Shutting Down Using the Suspend or Hibernation Function
Suspend/Hibernation Functions
Differences between the suspend and hibernation functions
The computer should be set for suspend or hibernation ( see the above proce-
dure).
Press the sleep switch; at the "beep*" sound, release your finger.
(After releasing your finger from the
sleep switch, do not touch the sleep
switch or the power switch while the
computer is in the suspend or hiberna-
tion modes.)
* When the speaker function is disabled, e.g., by setting [Disable] for [Speaker] with the
Setup Utility ( page 36) or by the key combination Fn + F4 , there will be no beep
sound.
1 Select [Start] - [Settings] - [Control Panel] - [Power Manage-
ment], in [Hibernate] add the check mark for [Enable hiber-
nate support] and press [Apply]
2 In [Advanced], select [Standby] or [Hibernate] for [When I
press the sleep button on my computer] and press [OK]
With Windows 98, the “Suspend” is called “Standby”.
NOTE
The operation of the power switch and the operation of the computer when the
LCD is closed can be set in [Advanced].
NOTE
To Next Page
Loading...
