28
1 Power off your computer ( "Starting Up/Shutting Down")
Do not shut down using the suspend* or hibernation mode.
2 Connect the external display to your computer
3 Turn on the external display, then turn on your computer
with the display opened
You can select either an external display, LCD or simultaneous with Fn
+ F3 (except when the computer is in the Dual-Display Mode).
In addition, you can set the display to use during start-up with the follow-
ing procedure.
External Display Port
Using an External Display
For more detailed information, refer to the operation manual of the
external display.
NOTE
1 Run the Setup Utility ( page 36)
2 Using and , select [Main]
3 Using and , select [Display] and press Enter
4 Using and , select the display to use and press
Enter
5 Press F10 , then select [Yes]
* With Windows 98, the "Suspend" is called "Standby".
4 Select your external display
Set your external display for [Monitor] in [Start] - [Settings] - [Control
Panel] - [Display] - [Settings] - [Advanced].
When a monitor that does not conform to the Plug & Play standards is
connected, select [Change] and make the monitor settings.
To Next Page
Loading...
