35
CAUTION
Ribs
Insert the ribs of the hard disk as shown in the figure, and while
slightly pushing the hard disk to the left put the hard disk in place.
Press down on these areas firmly.
2
Lift the hard disk drive to remove it from the connector and gently
set a new hard disk drive on to the connector.
Connector
5 Close the cover
Close the cover until it clicks into place; be sure the tab does not get
caught when closing the cover.
Hard Disk Drive
When closing the cover;
Be careful not to get your fingers caught in the cover.
There are instances the right side of the cover will float. In
such cases, attempt to close the cover again by putting the
projection on the right side of the cover below the keyboard.
Tab
To Next Page
Loading...
