102
Port Replicator
<CF-C1 Series with Port Replicator Connector>
You can use the following optional port replicator. This device frees you from being bothered by a lot of cable connections
when you carry the computer. It also allows you to connect various peripherals.
Connect the port replicator to the port replicator connector (A).
For further information, refer to the instruction manual of the port replicator.
NOTE
To use the port replicator, set [USB Port] setting to [Enabled] (default) in the [Advanced] menu of the Setup Utility.
When the port replicator is connected, following devices should be connected to the port replicator.
•LAN cable
• External display
Connect or disconnect the port replicator while the computer power is turned off.
To Next Page
Loading...
