36
Standby or Hibernation Functions
shut down and unsaved data will be lost even if you have set [Shut down] in [When I press the power button on my
computer:] (Î page 35 “Setting Standby or Hibernation”).
*1
If the speakers are muted, beeps do not sound.
In standby or hibernation
z Do not attach or remove a peripheral device. Doing so may cause malfunction.
z Power is consumed in standby. Power consumption may increase when a PC Card is inserted. When power is
exhausted, the data retained in memory will be lost. Connect the AC adaptor when using the standby function.
To resume from standby or hibernation
1 Open the display, or slide the power switch (A).
CAUTION
z Do not perform the following operations until resuming is complete. After the display is resumed, wait approximately
15 seconds (normally) or 60 seconds (when the computer is on a network).
• Touch the keyboard (except for password input), Touch Pad, touchscreen (only for model with touchscreen), or
power switch.
• Use an external mouse or other peripheral device.
• Connect or disconnect the AC adaptor.
• Close or open the display.
• Shut down or restart Windows.
• Enter standby or hibernation (Wait approximately one minute).
• Operate the wireless switch.
• Insert and remove the SD Memory Card.
To Next Page
Loading...
