71
Setup Utility
(Underlined items are the factory presets.)
Security Menu
Execute-Disable Bit Capability
• [Enable] indicates that this computer supports hardware-based Data Execution Prevention (DEP).
It should usually be set to [Enable].
Disable
Enable
Password on boot Disable
Enable
SD Startup
• Only when [Password on boot] is set to [Enable] and one or more SD card is registered
Disable
Enable
SD Setting Method
• Only when [SD Startup] is set to [Enable]
Leave Set
Set and Eject
XClear registered SD card Enter the sub-menu.
XSet Supervisor Password Enter the sub-menu.
Setup Utility Prompt
• When [Setup Utility Prompt] is set to [Disable], the message “Press F2 for Setup / F12 for LAN” is
not displayed on [Panasonic] boot screen. However,
F2
and
F12
will work even if the message
is not displayed.
Disable
Enable
Boot First Menu Disable
Enable
Hard Disk Lock Disable
Enable
User Password Protection No Protection
Protected
XSet User Password Enter the sub-menu.
XEmbedded Security (TPM) Sub-Menu
• Only for model with TPM
• For information on TPM, input [c:\util\drivers\tpm\README.pdf] in [start] - [Run] and refer to the
Installation Manual of “Trusted Platform Module (TPM)”.
Enter the sub-menu.
XComputrace (R) Sub-Menu Enter the sub-menu.
To Next Page
Loading...
