72
Setup Utility
*1
Use the Panasonic USB floppy disk drive (optional: CF-VFDU03)
*2
The devices under [Excluded from boot order] are not booted.
To change the boot order
To move up, select the device with Ï and Ð, and then press
F6
.
To move down, select the device with Ï
and Ð, and then press
F5
.
To move the device from [Excluded from boot order] to [Boot priority order] or vice versa, select the device with Ï
and Ð, and
then press
X
.
To return to the default setting, press
1
.
NOTE
z The default order is [USB FDD] -> [IDE HDD] -> [USB CDD] -> [PCI LAN].
z To boot from the following devices, make the settings as below.
z In the [Boot] menu, the names of the connected devices (including internal devices) will be displayed.
z If more than one of the same devices are connected, only one device name will be displayed.
z You can select the boot device during start-up of the computer, too. Press
Esc
soon after [Panasonic] boot screen is
displayed. [Boot Menu] appears and you can select the device. [Boot Menu] appears only when [Boot First Menu] in
Boot Menu
Boot priority order:
1: USB FDD:
*1
2: IDE HDD: xxxxxxxxxx
3: USB CDD:
4: PCI LAN: xxxxxxxxxx
5:
6:
7:
8:
Excluded from boot order:
*2
:USB KEY
:USB HDD
:USB LS120
To boot from
You need to set
• USB connected device : [USB Port] and [Legacy USB Support] to [Enable] (Î page 70)
• LAN : [LAN] to [Enable] (Î page 70)
To Next Page
Loading...
