37
Security Measures
You can set the password and/or enable/disable some functions for security purpose.
z Other security measures
• SD Security (
Î page 44)
• Embedded Security (TPM) (
Î page 71): For further information, refer to the Installation Manual of “Trusted Platform
Module (TPM)”.
Set the Supervisor Password before setting the User Password.
1 Start up the Setup Utility (Î page 68).
2 Select [Security].
3 Select [Set Supervisor Password] or [Set User Password], and press
Enter
.
4 Enter your password in [Enter New Password] and press
Enter
.
z When the password has been set, you need to enter your password in [Enter Current Password] and press
Enter
.
z To disable the password, leave the input field empty and press
Enter
.
5 Enter your password again in [Confirm New Password] and press
Enter
.
6 In [Setup Notice], press
Enter
.
7 Press
F10
, and then select [Yes] and press
Enter
.
CAUTION
z Do not forget your password. If you forget your Supervisor Password, you will not be able to use your computer. Con-
tact technical support office.
z When running the Setup Utility, do not leave and go away from your computer even for a short time, since other people
may set or change the password.
NOTE
z The password will not be displayed on the screen.
z You can use up to 32 alphanumeric characters (including spaces).
• The case (upper/lower) is ignored.
• Use only the upper horizontal row of numeric keys to input your password.
• You cannot use
Shift
and
Ctrl
to input a password.
z Disabling the Supervisor Password also disables the User Password.
Setting the Supervisor Password/User Password
To Next Page
Loading...
