40
PC Cards
2 Remove the card.
A Raise the bent part of the eject button.
B Press the eject button so the card comes out of the slot.
C Draw the card straight out.
NOTE
z Check the card’s specification to prevent the total operating current from exceeding the allowable limit. Otherwise mal-
function may occur.
Allowable Current: 3.3 V: 400 mA, 5 V: 400 mA
z After repeating insertion and removal, some types of card will not be recognized. In this case, restart the computer.
z If the computer freezes after resuming from standby or hibernation, remove and reinsert the card. If the problem per-
sists, restart the computer.
z When a card is inserted, power consumption increases. Remove the card when it is not in use, especially when oper-
ating by battery power.
z To connect peripheral devices (SCSI, IEEE1394, etc.) using a PC Card, follow the steps below (one example).
A Connect the peripheral device to the card.
B Turn on the power of device.
C Insert the card until it securely fits in the slot.
To Next Page
Loading...
