54
USB Devices
When using the Touch Pad Utility
1 Click [start] - [Control Panel] - [Add or Remove Programs] to remove the external mouse
driver.
z For further information, refer to the instructions manual of the mouse driver.
2 After the driver is removed, turn off the computer.
z If an external mouse is connected, disconnect it after turning off the computer.
3 Turn on the computer.
4 Click [start] - [Run] and input [c:\util\drivers\mouse\setup.exe] and then click [OK].
z Follow the on-screen instructions.
z At [Setup complete], confirm that [Yes, I want to restart my computer now] is set and click [Finish].
5 After restarting the computer, at [Synaptics Pointing Device Settings], remove the check
mark from [Show this screen at startup] and click [Close].
6 Click [start] - [Run] and input [c:\util\touchpad\setup.exe], and then click [OK].
z Follow the on-screen instructions.
z If the message [Touch Pad function and original Flat Pad scroll function cannot be used simultaneously] is
displayed after completing the installation, click [Yes].
A commercially available USB2.0 Hub connected to your computer may stop functioning if a USB2.0 printer is disconnected
from another port. This phenomenon may occur when a USB2.0 printer is connected to the USB port 1 on the mini port repli-
cator (CF-VEBU05AU).
Perform one of the following procedures.
z Connect the USB2.0 printer to the USB2.0 Hub.
z Connect the USB2.0 printer to the USB port (2a, 2b, 2c) on the mini port replicator (CF-VEBU05AU).
z Deactivate the power saving function of the USB2.0 Root Hub.
When you deactivate the power saving function, you can select two methods.
• Manually deactivate the power saving function of the USB2.0 Root Hub: Perform the following procedure
• Deactivate automatically the power saving function of the USB2.0 Root Hub: (Î page 55)
Manually deactivate the power saving function of the USB2.0 Root Hub
1 Click [start] - [Control Panel] - [Performance and Maintenance] - [System].
2 Click [Hardware] - [Device Manager].
When using a commercially available USB2.0 Hub
To Next Page
Loading...
