57
Modem
CAUTION
z Do not use the PBX internal phone lines installed in company offices. Doing so may lead to a fire or electric shock.
z You cannot connect the modem to the following lines.
• Interphone
• Intercom
•ISDN
z Be sure to connect the telephone cable into the modem port, not into the LAN port.
z Use a surge protector since the modem may be damaged by a sudden high voltage surge that may occur in the event
of a lightning strike.
1 Connect the computer and the telephone jack (A) using the
telephone cable (included: B).
z Hold the cable so that the shape of the connector (C) matches the port,
and insert fully until it clicks.
2 Click [start] - [Control Panel] - [Printers and Other Hardware]
- [Phone and Modem Options] and change the settings as
necessary.
NOTE
z Do not enter standby or hibernation during communications.
z To remove the cable, press and hold the lever and pull out.
A
To Next Page
Loading...
