61
LAN
C Click [Power Management], add or remove check marks for [Allow the computer
to turn off this device to save power] and [Allow this device to bring the computer
out of standby] to enable or disable the function, click [OK], and then click on
[Device Manager] screen to close.
CAUTION
z Be sure to connect the AC adaptor, and enable the power supply.
NOTE
z Even when a password is set in the Setup Utility and [Password on boot] is set to [Enable], it is not necessary to input
the password set in the Setup Utility when the computer resumes from standby or hibernation mode.
z The Wake up from LAN function will not operate under the following conditions:
• When the computer has been shut down
• When the power switch is slid over for four seconds or longer to turn off the power (e.g., when the computer hangs)
• When the AC adaptor and battery pack are removed from the computer or reattached to the computer
• When [LAN] is set to [Disable] in the Setup Utility
z After operations are resumed from standby mode, the screen remains dark. The former screen display will be
restored when the keyboard, Touch Pad or touchscreen is touched.
z The computer may start up if accessed by another computer on the network.
The following procedure can be used to prevent startup due to unintentional access by a computer.
A Click [start] - [Control Panel] - [Performance and Maintenance] - [System] - [Hardware] - [Device Manager].
B Double-click [Network adapters], double-click the internal network adaptor, and then click [Power Management].
C Add a check mark for [Only allow management stations to bring the computer out of standby], click [OK], and
then click on [Device Manager] screen to close.
To Next Page
Loading...
