Panasonic TX-32PS11F - Adjustment Procedure and Self-Check

ADJUSTMENT PROCEDURE
Item / Preparation Adjustments
+B SET-UP
1. Receive a Window pattern.
2. Set the controls :
Brightness Minimum
Contrast Minimum
Volume Minimum
Confirm the following voltages:
TPD1 205 ± 10V D9 pin3 9 ± 0,5V
TPD2 137 ± 2V D9 pin7 10,5 ± 0,5V
TPD3 42 ± 2V D2 pin22 3,3 ± 0,1V
TPD5 42 ± 2V D2 pin26 2,5 ± 0,1V
TPD6 12,5 ± 1V D2 pin14 3,3 ± 0,1V
TPD7 -12,5 ± 1V D9 pin5 5 ± 0,5V
TPD8 33 ± 2V D9 pin11 6,5 ± 0,5V
TPD11 5 ± 0,5V
CUT OFF / Ug2 Test
1. Receive a Window pattern.
2. Set Viewing Mode: Normal
3. Normalize the TV set.
4. Set brightness: Minimum
To adjust Cutoff connect an oscilloscope to the Blue cathode. Adjust
the screen VR until the black level is 160V +5V/-5V.
SELF CHECK
Self-check is used to automatically check the bus lines and hexadecimal code of the TV set.To enter Self-Check mode, press
the STATUS button on the remote control and at the same time press the down (-/v) button on the customer controls at
the front the TV set. To exit Self Check, switch off the TV set at the power button.
If the CCU
p
orts have been checked and found to be incorrect or not located then " - - " will a
pp
ear in
p
lace of "O.K.".
4
E2 O.K.
DDP O.K.
VSP O.K.
VPCD O.K.
A
VSW O.K.
TUN O.K.
MSP O.K.
DPL ---
MAS ---
SUM ****
TX-32PS11D TX-32PS11F TX-29PS11D TX-29PS11F
TX-32PS11D/B TX-32PS11P TX-29PS11D/B TX-29PS11P
TX-28PS11D TX-28PS11F
OPTION 1 0F 0F 0F 0F
OPTION 2 00 00 00 00
OPTION 3 B0 B0 A0 A0
OPTION 4 11 11 11 11
OPTION 5 00 00 00 00
OPTION 6 05 05 05 05
OPTION 7 7F 7F 7F 7F
OPTION 8 D0 50 D0 50
OPTION 9 00 00 00 00
OPTION 10 80 80 80 80
OPTION 11 1B 1B 1B 1B
OPTION 12 00 00 00 00
OPTION 13 0C 0C 0C 0C
CHECK CB 4B BB 3B
Black Level
160V+5V/-5V
GND
All manuals and user guides at all-guides.com