Frequently Asked Questions ●
FAQs, etc.
81
Problem Actions
HDMI
Sound is unusual
Set the sound setting of the connected equipment to ●
“2ch L.PCM”.
Check the “HDMI1 / 4 Input” setting in the Sound Menu. (p. 27)
●
If digital sound connection has a problem, select analogue sound ●
connection. (p. 77)
Pictures from external
equipment are unusual
when the equipment is
connected via HDMI
Check the HDMI cable is connected properly. (p. 70)●
Turn the TV and equipment Off, then turn them On again.●
Check an input signal from the equipment. (p. 78)●
Use an equipment compliant with EIA/CEA-861/861B.●
Network
Cannot connect to the network
Check the LAN cable is connected properly. (p. 51)●
Check the connections and settings. (p. 51 - 53)●
Check the network equipment and network environment.●
If the problem persists, consult your Internet Service Provider or
telecommunications company.
Cannot select the file during
DLNA operations
Is media server prepared? (p. 50)●
Check applicable data format. (p. 50)●
Cannot operate VIERA CAST
Check the connections and settings. (p. 51 - 53)●
The server or connected line might be busy now.●
Other
The TV does not switch On
Check the mains lead is plugged into the socket outlet.●
The TV goes into
“Standby mode”
Off Timer function is activated.●
The TV enters “Standby mode” about 30 mins. after analogue ●
broadcasting ends.
The remote control does not work
or is intermittent
Are the batteries installed correctly? (p. 8)●
Has the TV been switched On?●
The batteries may be running low. Replace them.●
Point the remote control directly at the front of the TV (within a ●
30 degree angle of the front of the TV).
Situate the TV away from sunshine or other sources of bright light
●
not to shine on the TV’s remote control signal receiver.
An error message appears
Follow the message’s instructions.●
If the problem persists, contact the authorized Service Centre.●
To Next Page
Loading...
