26
Function Parameter Table
No.
Parameter
(see Note 3)
Selections Function
000 MON/TEL DIAL 1 = Monitor
2 = TEL/DIAL
Selects whether the machine starts to
TX automatically during On-Hook dial-
ing.(Monitor: Start to TX after pressing
START)
(TEL/DIAL: Start to TX automatically)
001 ALARM STATUS 1 = OFF
2 = Timer (6 sec.)
3 = Constant
Selects the No Paper or No Toner alarm
status.
OFF : Alarm is disabled.
Timer : Alarm will shut off after 6
seconds.
Constant : Alarm will not stop until
"STOP" is pressed or the error is
cleared/corrected.
002 STOP COMM. JRNL 1 = Off
2 = On
Selects whether the machine prompts to
print the COMM. Journal when the
printout condition is set to INC and
STOP is pressed during
communication.
003 CONTINUOUS POLL 1 = Off
2 = Stn (Tx only)
3 = Hub (Rx only)
Selects whether the Continuous Polling
feature is enabled.
Stn:
Place the document(s) on the ADF then
press the Program Key [P8] to store or
add the document(s) into a polled file.
(See Note 4)
004 NUMERIC ID SET 1 = Off (will not accept)
2 = On (accepts)
Selects whether the machine accepts
and allows to set or change the Numeric
ID.
005 Not Used
006 ID DISPLAY 1 = Number (Numeric ID)
2 = Chara (Character ID)
Selects the priority of displaying the ID.
007 JNL COLUMN 1 = Preset station name
2 = Received ID
Selects the contents of the ID to display
on the Journal.
008 MONITOR 1 = Off
2 = On
Selects whether the Monitor is ON/OFF
for monitoring fax signals.
(FOR SERVICE USE ONLY)
009 DC LOOP 1 = Off (Normal)
2 = On (Off Hook)
Selects a false Off Hook state for back
to back communication test.
010 TX LEVEL 00 = 0 dBm
~
15 = -15 dBm
Selects the TX signal output level, 0 to
-15 dBm in 1 dBm steps.
(Refer to Chapter 4.3)
011 RX LEVEL 1 = -43 dBm
2 = -38 dBm
3 = -33 dBm
4 = -48 dBm
Selects the receiving sensitivity of -33/
-38/-43/-48 dBm.
(Refer to Chapter 4.3)
012 DTMF LEVEL 00 = 0 dBm
~
15 = -15 dBm
Selects the DTMF output level, 0 to -15
dBm in 1 dBm steps.
To Next Page
Loading...
