72
123
Viewing on TV Screen
1 Turn on the TV and set the input selector to the
Input connection the DVD Video Camera is
connected to. This is often refered to as “line”.
Refer to the TV instruction manual for how to
switch the TV input.
2 Turn the DVD Video Camera on.
The image that the DVD Video Camera is
viewing will appear on the TV screen.
You can also monitor the image on the LCD
screen or viewfinder of the DVD Video Camera.
3 Perform playback, recording or editing.
You can perform playback, recording or editing in
Disc Navigation while viewing on TV screen.
Note:
• Adjust the sound volume on TV.
• The infrared remote controller is useful when operating
the DVD Video Camera while viewing an image on TV
screen.
• Information that the DVD Video Camera is recording will
appear on the TV screen: You can also display only part
of information or switch off the display. Refer to “Setting
OSD Output On or Off (On-Screen Display)” on page 90,
and press the DISPLAY button to switch the display
status.
• When copy-guarded disc is played back, no image will
appear on TV screen.
• If you use TV with wide mode (aspect ratio 16:9) and set
the TV to wide mode, the entire Disc Navigation display
may not be displayed on the TV screen. If this happens,
turn off the wide mode setting on TV (see the TV
instruction manual for turning off the wide mode).
VDR-M95M75M55M53PP.book Page 72 Tuesday, March 29, 2005 2:19 PM
To Next Page
Loading...
Need help?
General
