First Time Setup
The setup screen will be displayed only when the TV is turned on for the first time and after the power cord
is inserted into a wall outlet.
Turn the TV on with the POWER button
(TV) (Remote)
POWER
or
Setup the following items
® SeJect your language
® Select your viewing mode (Be sure to select "Home Use")
If you select "Store Demonstration" by mistake, confirmation screen will be
displayed.
To display the "Set viewing mode" screen again and select "Home Use", perform
"Reset to defaults" in the "Setup" menu.
® ANT/Cable setup
Select signal type (Over-the-air Antenna/Cable).
Select Auto Program and start scanning.
Scanning starts.
If at the end of the scanning no channels are found, then check:
1.Antenna's position - or
2. Availability of Cable service
Cable, Satellite or Fiber services with a box are typically connected to the TV's A/V
inputs, preferably HDMI, for best HD picture. In such a case, the channel scanning is
not needed (set "ANT in" to "Cable").
Complete First time setup
Completion screen is displayed.
You can repeat the First time setup
• Press MENU -> Setup -> Reset to defaults
|
To watch TV via a Cable box, Satellite receiver, or any other source (DVD, DVR, |
gaming device, etc.), press the iNPUT button and select the appropriate input.
J
®®
___',q.
,<
5"
({:3
©
q--o
©
13
To Next Page
Loading...
