Panasonic Viera TX-L42ET5Y

Accessories / Options
Quick Start Guide
8
Assembly screw (4)
M5 × 15
Assembly screw (4)
M4 × 25
Bracket

TBL5ZA32911 (TX-L32ET5Y)

TBL5ZA32912 (TX-L32ET5YW)

TBL5ZA32831 (TX-L37ET5Y)

TBL5ZA32922 (TX-L42ET5YW)

TBL5ZA32921
TX-L42ET5Y
TX-L47ET5Y
TX-L55ET5Y
()
Base

TBL5ZX03551 (TX-L32ET5Y)

TBL5ZX03553 (TX-L32ET5YW)

TBL5ZX03541 (TX-L37ET5Y)

TBL5ZX03531 (TX-L42ET5Y)

TBL5ZX03535 (TX-L42ET5YW)

TBL5ZX03511 (TX-L47ET5Y)

TBL5ZX03851 (TX-L55ET5Y)
1
Assembling the pedestal
Use the assembly screws to fasten the bracket
to the base securely.

Make sure that the screws are securely
tightened.

Forcing the assembly screws the wrong way
will strip the threads.
2
Securing the TV
Use the assembly screws to fasten securely.

Tighten the four assembly screws loosely at first, then
tighten them firmly to fix securely.

Carry out the work on a horizontal and level surface.
B
Arrow mark
Hole for pedestal
installation
D
C
A
Front
Tab (top)
Removing the pedestal from the TV
Be sure to remove the pedestal in the following way
when using the wall-hanging bracket or repacking
the TV.
1 Remove the assembly screws
from the TV.
2 Pull out the pedestal from the TV.
3 Remove the assembly screws from the bracket.
Adjusting the panel to your desired angle

Do not place any objects within the full rotation range.
15°
15°
(View from the top)
Preventing the TV from falling over
Using the fall-prevent screw hole and a screw (commercially available), securely fix the body of the pedestal to the
installation surface.

The place where the pedestal is to be fixed should be thick enough and made of hard material.
Screw (not supplied)
Diameter
55 inches model: 4 mm
Other inches model: 3 mm
Length: 25 - 30 mm
Screw hole