On-screen messages
120
Message Meaning / Action
No recording - Check media
The tape or disc may be “write protected”, full, missing or damaged.
No recording - Playing
The equipment may be playing the tape or disc.
No recording - Unknown
reason
The recording may not be performed. Check the equipment.
No service
The broadcaster has stopped the service. Check the channel in the TV Guide.
(p. 26)
No signal
The TV cannot detect the signal. Check the connection of the RF cable.
Overcurrent error on USB
device occurred.
Please remove the USB device,
and switch off the TV by mains
power switch.
The connected USB device might cause overcurrent error. Follow the on-
screen instructions.
Check if foreign objects are inside the USB port.
PIN incorrect!
The PIN number you entered is wrong.
Please check settings and
connections on HDMI devices.
Communication error in VIERA Link function (p. 100).
Please enter a frequency
between 10700 and 12750 MHz.
The frequency you entered is out of range. Consult the received satellite
broadcasting company
. (p. 63)
Please wait.
A function is in progress.
Recording this channel now
The recorder is recording the programme from its own tuner. You can turn the
TV off and leave the equipment recording in the normal way
.
Reset to Factory Shipping
Condition Completed. TV will
automatically restart. Do not
turn off
[Auto Setup] will automatically start (p. 17).
Sending Preset Data
Q-Link or VIERA Link channel download is in progress.
Software successfully updated.
Press EXIT to continue.
The software updating is finished.
Software update failed. Please
try again later.
Press EXIT to continue.
Perform [System Update Search Now] in System Update (p. 70).
If this is still unsuccessful, there may not be any new software available.
The device is not directly
connected to the TV.
The device may not work
correctly.
Please do not connect the device via a USB HUB.
This device will be formatted
and all contents deleted. Are
you sure?
Once you format the USB HDD, all the recorded programme will be erased.
This timer will not follow the
TV Guide information.
Press OK to continue, RETURN
to restore original timer.
If you edit the start time or end time of Guide link programming by more than
10 minutes, it will no longer be performed as Guide link programming. The
programming will be performed according to the time setting.
Timer already expired !
The starting time in Timer Programming has already passed. Set the timer
correctly (p. 64).
Timer incorrect !
Set the start and end times in Timer Programming correctly (p. 64).
Timer overlap.
Press OK to keep, RETURN
to edit.
Timer programming events are overlapped. Press the OK button to keep the
overlapped setting. [Ext Rec.] and [USB HDD Rec.] are given priority over
[Reminder]. When two or more [Ext Rec.] / [USB HDD Rec.] overlap, the first
timer programming event starts and finishes as programmed. The next timer
programming event can then start.
Tuner Locked
Press EXIT to unlock and stop
recording
If you want to unlock the tuner, cancel Direct TV Recording (p. 99, 101), the
recording of T
imer Programming (p. 64) or One Touch Recording.
Unable to download, please
check equipment
The tape or disc is active. Stop the equipment and try again.
3D image not available.
You may use a function not available for 3D effect. Exit the function to view the
3D images.
To Next Page
Loading...
