EasyManua.ls Logo

Panasonic Viera TX-L42WT50E

Panasonic Viera TX-L42WT50E
124 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
USB HDD / SD Card Recording
72
4 Confirmation to enable USB HDD for recording
If the formatted USB HDD for recording already exists, this confirmation screen will be displayed to switch to enable
this USB HDD for recording.
Do you want to enable this
device now for recording?
When disconnecting any USB device,
always use the "Safely Remove USB" function
in the USB HDD Device Setup menu to avoid
any corruption of recorded content.
USB HDD Formatting
Yes No
select [Yes]
set
USB Drive A
USB Flash Disk
USB HDD 1
USB HDD Setup
Product Name
USB HDD name is displayed
Mode
:
The USB HDD is available for recording / playing back.
Only one USB HDD on the list is available for recording.
:
The USB HDD is available for playing back.

To format
(red)

To edit USB HDD name
(green)

To change the mode

To remove the USB HDD safely from the TV
(yellow)
To set “Safely remove USB” in other conditions (p. 23)
SD Card Formatting
Formats the inserted SD Card.

Please note that all data in the SD Card will be erased after formatting.
Caution and confirmation of using SD Card and start format
SD Card Formatting
Are you sure?
Yes No
Format SD card.
All data stored on the SD card will be deleted during
formatting. Continue?
SD Card Formatting
Yes No
select [Yes]
set
select [Yes]
set

If the formatting has failed,
Ensure the SD Card is inserted correctly. (p. 70)
Ensure the write-protection switch is unlocked.
Check your SD Card is suitable for recording. (p. 111)
One touch direct TV recording - What you see is What you record [One Touch Recording]
Records the current programme in the USB HDD or the SD Card immediately.

Confirm the code of the remote control is “73” (p. 31).
Select the maximum recording time [30] / [60] / [90] / [120] / [180] (minutes)
Recording Setup
One Touch Recording 180 minutes
select
access / store

LED will turn to orange (flash) while One
Touch Recording is in progress.
“Indicator / Control panel” (p. 12)
Default REC Mode
You can select default recording mode for [One Touch Recording].
“Recording time for the USB HDD / SD Card Recording” (p. 111)
[DR]: Direct recording (normal mode)
[LT1]: Long time recording
[LT2]: Extra long time recording

Related product manuals