Panasonic Viera TX-P42ST60E - Page 8

English
8
■ Assembling the pedestal
5
A
A
B
F
1
2
3
4
6
B
A
C
D
E
42-inch model
50-inch model
42-inch model
50-inch model
55-inch model
65-inch model
42-inch model
50-inch model
55-inch model
65-inch model
■ Adjusting the panel to your desired angle
42-inch model
50-inch model
●
Do not place any objects within the full rotation range.
15°
15°
(View from the top)
42-inch model
50-inch model
Secure the base as shown below to prevent the TV
from falling over.
●
The place where the base is secured should be thick
enough and made of hard material.
Commercially available screw
(not supplied)
Diameter: 3 mm
Length: 25 - 30 mm
Removing the pedestal from the TV
Be sure to remove the pedestal in the following way when using the wall-hanging bracket or repacking the TV.
1 Remove the assembly screws
(
42-inch model 50-inch model
) / (
55-inch model 65-inch model
) from the
TV.
2 Pull out the pedestal from the TV.
3 Remove the assembly screw from the cover.
42-inch model 50-inch model
4 Pull out the cover.
42-inch model 50-inch model
5 Remove the assembly screws from the bracket.
6 Remove the assembly screws from the back of the base and pull out the neck.