11.1.2.2 White Balance Adjustment
The adjustment is done only when the color of the LCD display has changed after you have replaced the LCD.
(Basically, adjustment is unnecessary.)
1. Select “TECHNICAL MODE 1” by [F2] or [F3].
Press [F4(DECIDE)].
2. Select “WHITE BALANCE” by [F2] or [F3].
Press [F4(DECIDE)].
3. Set to default value.
(1) Select the color by [F2] or [F3]
(2) Press [F4 (DECIDE)]
(3) Set to default value as below
•
[F1] (>>): (Select Digit)
•
[F2] (▼), F3 (▲): (Change Value)
-
R Gain: 03e0
-
G Gain: 0410
-
B Gain: 0410
(During the adjustment, the color of the screen will change)
- 57 -
To Next Page
Loading...
