1.3 General information
R In the event of problems, you should contact your equipment supplier in the first instance.
R The available products differ depending on your region. For more information, please consult your dealer.
R In this document, the suffix of each model number (e.g., the "BX" in "VL-SWD272BX") is omitted unless necessary.
When the suffixes are used to describe models (e.g., "BX models"), the suffixes refer to all models in the series.
R Design and specifications are subject to change without notice.
R The illustrations in the supplied document may vary slightly from the actual product.
House mode and Apartment mode
The main monitor can be configured to be used in two modes: House mode and Apartment mode.
R House mode refers to when the main monitor is used as a stand-alone system and is not connected to a larger
system comprised of a VL-V900 lobby station. This document describes the operations for House mode.
R Apartment mode refers to when the main monitor is used connected to a larger system comprised of a VL-V900
lobby station, such as in apartment complexes. Operations for Apartment mode are described in 6 VL-V900 basic
operations (Page 14) of this document.
For further information about features and operations, visit our Web site and find the document:
http://panasonic.net/pcc/support/intercom/swd272
For Europe
Declaration of Conformity:
R Panasonic System Networks Co., Ltd. declares that the radio equipment type (VL-SWD272BX/VL-SWD272CX)
is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address:
http://www.ptc.panasonic.eu/doc
Contact to Authorised Representative:
Panasonic Testing Centre
Panasonic Marketing Europe GmbH
Winsbergring 15, 22525 Hamburg, Germany
Ecodesign information
Ecodesign information under EU Regulation (EC) No. 1275/2008 amended by (EU) Regulation No. 801/2013. From
1 January 2015.
Please visit here: www.ptc.panasonic.eu/erp
Click [Downloads]
a Energy related products information (Public)
Power consumption in networked standby and guidance are mentioned in the Web site above.
Graphical symbols for use on equipment and their descriptions
1
2 3 4 5 6
7 8 9 10 11 12
1. Alternating current (A.C.) 2. Direct current (D.C.) 3. Protective earth 4. Protective bonding earth 5. Functional earth
6. For indoor use only 7. Class P equipment (equipment in which protection against electric shock relies on Double
Insulation or Reinforced Insulation) 8. "ON" (power) 9. "OFF" (power) 10. Stand-by (power) 11. "ON"/"OFF" (power;
push-push) 12. Caution, risk of electric shock
3
1. Introduction
To Next Page
Loading...
