Panasonic WJ-RT416 - Page 4

4
4-pin connector
8-pin connector
Codec boardData Multiplex board
CPU board
13-pin connector
12-pin connector
Extension Data Multiplex board (this unit)
Stud
c Connect the blue connectors of 12-pin and 13-pin cables that are supplied to the corresponding blue connectors
of the CODEC board below the Data Multiplex Board. Then, connect the blue connectors of 4-pin and 8-pin
cables that are supplied to the corresponding blue connectors of the CPU board.
v Set all the switches (S1 - S4) on the main board of the recorder to "OFF".
ON
1 2 OFF
ON
12
ON
12
ON
12
b Secure the Data Multiplex Board with the attached 4 studs using a box driver. Then, install the additional Data
Multiplex Board (this product) on the secured Data Multiplex Board with the 4 screws that were removed in the
step 2.