Panasonic WV-CW384

23
Setting Procedures
First, select a language for menu display and camera ID display.
Language Setup (LANGUAGE SETUP)
1. Select "LANGUAGE" on the top menu and press the [SET] button.
→ The "LANGUAGE SETUP" menu opens.
2. Select a language. The default setting is "ENGLISH".
Available languages: ENGLISH, FRANÇAIS, ESPAÑOL,
DEUTSCH, ITALIANO, êìëëäàâ, CHINESE or JAPANESE
3. Select "SET" on the menu and press the [SET] button.
1. On the "CAMERA SETUP" menu, select "ON↓" or "OFF↓" for
"CAMERA ID" and press the [SET] button.
ON↓: Displays entered camera ID.
OFF↓: Does not display the ID.
→ The "CAMERA ID" menu opens.
2. Select a character from the character area and press the [SET]
button.
→ The selected characters are displayed in the editing area.
1. Camera Identification Setting (CAMERA ID)
Assign a name to the camera using up to 16 characters to display it overlaying on the camera picture in the selected position.
Note:
• If you change the language selection after the assignment of camera ID, it will be erased.
**CAMERA SETUP** 1/2
CAMERA ID OFF
ALC ALC
SHUTTER OFF
AGC ON(HIGH)
SENS UP OFF
SYNC INT
WHITE BAL ATW1
MOTION DET OFF
DNR HIGH
RESOLUTION HIGH
BW MODE
**LANGUAGE SETUP**
LANGUAGE ENGLISH
SET
RET TOP END
3. Repeat these procedures until all characters are entered.
• To enter a blank space, select "SPACE" and press the [SET]
button.
• To replace a specific character in the editing area:
1. Move the cursor to the editing area and then move the
pointer to the character to be replaced pressing the
[LEFT] and [RIGHT] buttons.
2. Move the cursor to a candidate character in the character
area and press the [SET] button.
• To erase all characters of the camera ID, select "RESET" and
press the [SET] button.
Note:
• For Chinese language, up to 8 characters can be entered.
CAMERA ID
0123456789
ABCDEFGHIJKLM
NOPQRSTUVWXYZ
().,'":;&#!?=
+-*/%$
SPACE POSI
RET TOP END RESET
................
Character
Cursor
Pointer
Character
Area
Command
Editing
Area
FLOOR 1
Highlighted