Panasonic WV-CW504S

20
Configure frame display
Follow the procedure below.
Step 1
Move the cursor to "i-VMD" and press the setting button.
→ The "i-VMD SETUP" screen appears.
Step 2
Move the cursor to "INDICATOR" and determine whether or not to display a frame around the screen from the following.
OFF (default): Does not display a frame.
ON(ALL): Displays a frame.
ON(OBJ): Display the appearance/disappearance frame only.
Configure alarm notification
Follow the procedure below.
Step 1
Move the cursor to "i-VMD" and press the setting button.
→ The "i-VMD SETUP" screen appears.
Step 2
Move the cursor to "ALARM" and configure alarm notification.
CONT (default): Continues to send alarm signals upon detection.
1TIME: Sends an alarm signal only once (100 ms) at detection start.
**i-VMD SETUP**(1)
MOTION DET
OBJECT DET OFF
SCENE CHANGE OFF
INDICATOR OFF
ALARM CONT
RET TOP END
"i-VMD SETUP" screen
**CAMERA SETUP**
SCENE1
ALC ALC
SHUTTER OFF
AGC ON(HIGH)
SENS UP OFF
WHITE BAL ATW1
DNR HIGH
BW MODE AUTO1
i-VMD
RET TOP END
"CAMERA SETUP" screen
**i-VMD SETUP**(1)
MOTION DET
OBJECT DET OFF
SCENE CHANGE OFF
INDICATOR OFF
ALARM CONT
RET TOP END
"i-VMD SETUP" screen
**CAMERA SETUP**
SCENE1
ALC ALC
SHUTTER OFF
AGC ON(HIGH)
SENS UP OFF
WHITE BAL ATW1
DNR HIGH
BW MODE AUTO1
i-VMD
RET TOP END
"CAMERA SETUP" screen