10
Booster function
The booster function [B] grants a boost of power to the selected heating zone.
I
f
this function is activated the heating zones work during 5 minutes with an ultra high power.
The booster is foreseen for example to heat up rapidly big quantities of water, like nuddles.
• Start up / Stop the booster function:
Action Control panel Display
Zone selection Press key [ 0 ] from the zone [ 0 ] and control light on
Start up the Booster Press key [ B ] [ P ] during 5 min
Stop the Booster Slide on the “SLIDER“ [ P ] to [ 0 ]
Or press [ B ] [ 9 ]
• P
ower management:
The cooking hob is equipped with two booster functions. When the booster function is activated,
and not to exceed the maximum power, the electronic system orders to reduce automatically the
power level of an other heating zone. The display is blinking on [ 9 ] during a few seconds and
then shows the maximum of power allowed :
Heating zone selected The other heating zone: (example: power level 9)
[ B ] is displayed [ 9 ] goes to [ 7 ] depending the type of zone
Timer
The timer is able to be used simultaneous with all 3 heating zones and this with different time
settings (from 0 to 99 minutes) for each heating zone.
• Setting and modification of the cooking time :
Example for 16 minutes at power 7 :
Action
Control panel Display
Zone selection press display [ 0 ] selected [ 0 ] and control light on
Select the power level slide on the “SLIDER“ to [ 7 ] [ 7 ]
Select « Timer » press display [ CL ] [ 00 ]
Set the units slide on the “SLIDER“ to [ 6 ] [ 0 fixed ] [ 6 blinking ]
Valid the units press display [ 06 ] [ 0 blinking ] [ 6 fixed ]
Set the tens slide on the “SLIDER“ to [ 1 ] [ 1 blinking ] [ 6 fixed ]
Valid the tens press display [ 16 ] [ 16 ]
The time is confirmed and the cooking starts.
• To stop the cooking time:
Example for 13 minutes at power 7 :
Action Control panel Display
Zone selection press display [ 0 ] selected [ 0 ] and control light on
Select « Timer » press key [ 13 ] [ 13 ]
Deactivate the units slide on the “SLIDER“ to [ 0 ] [ 1 fixed ] [ 0 blinking ]
Valid the units press display [ 10 ] [ 1 blinking ] [ 0 fixed ]
Deactivate the tens slide on the “SLIDER“ to [ 0 ] [ 0 blinking ] [ 0 fixed ]
Valid the tens press display [ 00 ] [ 00 ]
• Automatic stop at the end of the cooking time:
As soon as the selected cooking time is finished the timer displays blinking [ 00 ] and a sound rings.
To stop the sound and the blinking it is enough to press the key [ 00 ].
To Next Page
Loading...
