12
Pau
se
function
This function defines all the hob’s cooking activity and allows restarting with the same settings.
• Startup/stop the pause function :
Action Control panel Display
Engage pause press [ ] during 2s displays [ II ] in the
heating zone displays
Stop the pause press [ ] during 2s pause control light is
blinking
press an other touch or pause control light is off
slide on the “SLIDER“
Recall Function
After switching off the hob (
), it is possible to recall the last settings.
• cooking stages of all cooking zones ( power )
• minutes and seconds of programmed cooking zone-related timers
• Automatic heat up function
The recall procedure is following:
• Press the key [ ]
• Then press the key [ ] within 6 seconds
The precedent settings are activated.
“Keep warm” Function
This function allows to reach and maintain automatically a temperature of 70°C.
Th
is will avoid liquids overflowing and fast burning at the bottom of the pan.
• To engage, to start the function « Keep warm » :
Action Control panel Display
Zone selection Press display [ 0 ] selected [ 0 ] to [ 9 ] or [ H ]
To engage (72º) Press on key [ ] on the “SLIDER“ [ U ]
To stop Press on display [ ] selected [ U ]
Slide on the “SLIDER“ [ 0 ] to [ 9 ] or [ H ]
This function can be started independently on all the heating zones.
When the pan leaves the cooking zone of the "Keep warm" function remains active during
approximately 10 minutes.
The maximum duration of keeping warm is 2 hours.
To Next Page
Loading...
