37
•1/2” (12-mm)- or 3/4” (18-mm)-wide tape is installed and the text contains only
capital letters
•3/4” (18-mm)-wide tape is installed and the characters are not formatted (i.e., the
underline or frame setting is not applied)
To change the size setting:
1 While holding down , press once, and keep held down to display
the current size setting.
2 While still holding down , continue pressing until the desired size setting
is displayed.
☞ The current character size setting is also shown by the size indicators above the
display.
3 Release to apply the selected size setting to the entire text.
EXAMPLE
Tape
width
Te x t
lines
1/4”
(6 mm)
3/8”
(9 mm)
1/2”
(12 mm)
3/4”
(18 mm)
1 12 pts 18 pts
All caps: 29 pts
Not all caps: 24 pts
All caps, not formatted: 57 pts
All caps, formatted: 45 pts
N ot all c aps, not formatted: 45 pts
N ot all c aps, f or matted: 36 pts
2 N/A 9 pts 12 pts 18 pts
3 N/A N/A N/A 12 pts
4 N/A N/A N/A 9 pts
Le ngth
Dependent
6 pts (only fon t size available) f or Rota ted Leg end or Repe at L egen d ON
To select the 24 point size setting:
1 While holding down , press
once, and keep held
down.
Code
1
Size
Code
Code
1
Size
Code
Caps
Length
Rotate A
A
A
A A Auto
Underline
Frame
Repeat
Legend
AUTO
SIZE
Code
1
Size
Code
To Next Page
Loading...
