Panduit LS7 - Barcode Function

60
BARCODE FUNCTION
The barcode function enables barcodes to be printed as part of labels. Four different param-
eters enable you to create custom barcodes.
The default settings are CODE 39 PROTOCOL, LARGE WIDTH , HUMAN READ-
ABLE set to ON, and CHECK DIG. set to OFF.
Barcodes must be entered according to the following rules:
To use the barcode function:
1 Hold down and press .
☞ To change the data or parameters of a barcode that has already been created,
position the cursor below the barcode mark ( ) before holding down
and pressing .
A label can only contain one barcode. If a barcode has already been entered
when is held down and is pressed, the error message “1 BAR
CODE / LABEL” will appear.
To quit the barcode function without making any changes, hold down
Parameter Settings
PROTOCOL CODE 39
WIDTH (barcode width) LARGE, SMALL
HUMAN READABLE
(numbers printed below bar-
code)
ON, OFF
CHECK DIG. (check digit) OFF, ON
Protocol
Number of digits (includ-
ing check digits and start
and stop codes)
Characters that
can be used
Notes
CODE 39 4 through 22
Numbers, letters,
spaces, and
symbols –, $, /, +,
and %.
The asterisk (*)
is not needed as
start and stop
codes.
Code
N
Barcod
e
Code
N
Barcod
e
Code
N
Barcode
Code