118
5. If your shared folder path is displayed at the network path, it means it is successfully shared.
9.3.5.2. “Scan to SMB” configuration
1. Be sure the printer and the computer are both switched on and connected with each other
properly.
2. To configure SMB address book, please see Section 6.2.3.4.
3. Put an original on the glass platen or into the ADF (please see Chapter 2.5 for how to put an
original).
4. Press “Scan” on the control panel to enter the scanning interface.
5. Press “▲” or “▼” to select “Scan to SMB” - “SMB Address Book”, then press “OK”.
6. Press “▲” or “▼” to select the server, then press “OK”.
7. Press "Menu" and then "OK" to enter the "Scan Setting" interface.
8. Select scanning parameters according to your needs, then press “Start” to start scanning.
9.4. Cancel Scan Job
During the scanning, two ways are available to cancel the job:
1. Press "Cancel" button on the control panel to cancel the job.
2. Click Cancel button on the scan progress bar interface of the computer to cancel the job.
To Next Page
Loading...
Need help?
General